Allied Telesis AT-FS724 - Manual (Page 26)

,QVWDOODWLRQ
2-6
5. Apply power to the unit as follows:
Caution
Power cord is used as a disconnection device. To de-energise
equipment disconnect the power cord.
' 10
Attach the power cord to the unit and plug it in the power
source. Verify that the POWER LED lights green. See Table 2-1
on page 2-4.
As power is applied to the switch, the FAULT LED flashes as the
switch runs internal self testing.
If the POWER LED does not light green, see Chapter 3,
"Troubleshooting", for further information.
6. Connect the data cables, making sure each connection has a good
valid link and that the switch is receiving packets.