Allied Telesis AT-8324SX - Manual (Page 43)

AT-8324SX Installation Guide
43
Stacking
A stack can have as many as four switches.
Note
A stacking cable is included with the AT-BSTACK1 Stacking Module.
Caution
Do Not stack AT-8324SX switches with other devices. Doing so may
damage the switch.
To stack the devices, perform the following procedure:
1. Locate the stack connectors labeled "UP" and "DOWN" on the stack
modules (see Figure 14).
Figure 14 Stacking the Switches
2. Attach one end of the stacking cable to the stack connector labeled
"DOWN" on the top device, and the other end to the connector
labeled "UP" on the next lower device.
3. Repeat this step until all the devices have been connected.
4. Refer to Connecting to a Power Source on page 44.