Allied Telesis AT-S25 - Manual (Page 55)

AT-S25 Version 1.4 User’s Guide
55
Configuring the RS232 Port on the Master Switch
The default settings for the RS232 port on the front panel of the Ethernet
switch are as follows:
❑ Baud rate: 9600
❑ Data bits: 8
❑ Stop bits: 1
❑ Parity: None
❑ Flow control: None
To change the settings for the RS232 port on the master switch, perform
the following procedure:
1. From the Main Menu, select the master switch.
Note
You must select the master switch to perform this procedure. Do not
select a slave switch.
2. From the Main Menu, select System Configuration.
The System Configuration menu in Figure 7 on page 39 is
displayed.
3. From the System Configuration menu, select Terminal Configuration.