Allied Telesis OmniConnect ISDN User Manual
Omniconnect isdn, Quick install guide
Advertising
Table of contents
Document Outline
- OmniConnect ISDN
- Regulatory Compliance Information
- 1. The telephone number to which this unit is connected.
- 2. The ringer equivalence number.
- 3. The USOC jack required [RJ11C]
- 4. The FCC Registration Number [xxxUSA-xxxxx-xx-e]
- 1. Interconnection directly, or by way of other apparatus, of ports marked U, S/ T, and Phone wit...
- 2. The BRI connector must be hardwired permanently to the S-reference connection point by using a...
- 3. This apparatus must be connected to a main socket outlet with a protective earth contact.
- 4. Connection of power supply: LanEdge OmniConnect ISDN internet access devices are intended for ...
- Table of Contents
- Overview
- Work sheet
- Topology
- Chapter 2
- Installation
- Verifying OmniConnect ISDN Package Contents
- Placing the OmniConnect
- 1. Do not install the rubber feet or bumpers if you are wall mounting the product. If you previou...
- 2. Prepare the wall by installing two screws (provided) at 9 1/4-inch (23.5 cm) apart on center.
- 3. Position the unit onto the screws. Skip to “Connecting the OmniConnect” on page8.
- 1. Place the unit upside down.
- 2. Locate the round rubber feet and square rubber bumpers from the accessory bag. Remove the pape...
- 3. Put the unit on the desktop. Skip to “Connecting the OmniConnect” on page8.
- 1. Select the base unit and place it upside down on a work surface. Locate the rubber feet and bu...
- 2. Place each of the other units upside down on a work surface. Locate the rubber feet and bumper...
- 3. Place the first LanEdge unit on the desktop as the base. If you are installing a FastPrint Ser...
- 4. Pry off the interlock cap at each corner of the unit: From the side of the unit, insert the ti...
- 5. Place the next unit over the base (stack) and press down on each corner to snap the units toge...
- 6. Repeat steps 4 and 5 until all units are in the assemblage.
- 7. Continue with the installation instructions for each product, and then return to “Connecting t...
- Connecting the OmniConnect
- 1. Connect the ISDN cable to the OmniConnect at the rear panel connector. For the other end,
- 2. Connect a telephone (optional) to the POTS connector at the rear panel using a RJ11 telephone...
- 3. Connect the Ethernet LAN devices to the OmniConnect at the rear panel connectors. Use a straig...
- 4. Apply power to the OmniConnect as follows:
- 5. Verify that the Ethernet LEDs light green (see LED table).
- Verify your PC Configuration
- Load OmniStart on the Host PC
- Configuration Screens
- LanEdge Publications
- Allied Telesyn International, Corp. 19015 North Creek Parkway Bothell, WA 98011 Tel: 1 (425) 487-...
- Allied Telesyn International, Corp. 960 Stewart Drive, Suite B Sunnyvale, CA 94086 Tel: 1 (800) 4...
- AppendixA
- AppendixB