Allied Telesis AT-TS24TR - Manual (Page 38)

TurboStack Hubs with Management
21
5. Separate the AUI appliqué connector plate (shown in Figure 15) from
the ribbon cable (shown in Figure 16) by rotating the cable 90
°
and
sliding it through the slot in the connector plate.
6. Store the detached AUI appliqué plate, slide kit screws, washers, and
nuts in a secure container for future use.
To install a 10BASE2, 10BASE-T or fiber Optic (10BASE-FL)
appliqué
1. Remove the AUI appliqué (as described above).
2. Plug the replacement 10BASE2, 10BASE-T, or 10BASE-FL appliqué
into the AUI connector, as shown in Figure 17.
Figure 16: AUI Connector and
Ribbon Cable
Assembly
Figure 17: Appliqué
Installation
AUI
connector
Ribbon cable
without
connector plate
Replacement
cover plate
AUI connector
Replacement
appliqué