Allied Telesis AT-MC106XL - Manual (Page 11)

AT-MC105XL and AT-MC106XL Installation Guide
5
Installing the Media Converter
Read the warnings below before beginning any installation.
Warning
LIGHTNING DANGER: DO NOT WORK on equipment or CABLES
during periods of LIGHTNING ACTIVITY
! 1
DO NOT BLOCK AIR VENTS ! 2
The following steps are for a standalone installation. To install media
converters in a rack-mount chassis, see “Rack-mount Chassis Installation” on
page 7. For information concerning back-to-back converter configuration, see
“Back-to-Back Installation” on page 7.
Standalone Installation
1. Remove all equipment from the package and store the packaging in a safe
place
2. Attach the four rubber feet to the base of the unit, placing one rubber foot
in each corner. For rack-mount installation, do not attach the four rubber
feet.
3. Plug the AC-DC power adapter into an appropriate AC power outlet and
insert the power plug into the DC receptacle located on the rear panel.
Figure 4 12 V DC Connector on Rear Panel
4. Verify that the PWR LED lights green.
5. Set the unit in Link Test Mode
6. Remove the dust cap from the fiber optic connectors.
7. Plug the appropriate fiber cable into the connector. See Table 3 for IEEE
802.3u cabling specifications
8. Connect the other end of the fiber cable to the desired end station. Verify
that the link LED is ON.
12 V D C