Hubbardton Forge 138589 - Manual

Assembly & Installation Instructions
A317
Aura LED Lg Pendant 13-8589D Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 27825
To Install to Ceiling (Figures 1 thru 5)
Component Parts
A Ceiling Bracket
B Lag Screw (3)
C Canopy
D Canopy Support Cable
E #8 Screw
F Support/supply Cable (3) G Cable Gripper (3)
H Flat Head Screws (2)
I
Canopy Nipple
J Canopy Cover
K Knob
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton. Put the ceiling
bracket (A) and canopy (C) together, making sure the canopy
mounting holes match up with the ceiling bracket threaded
standoffs. Orient them to achieve desired wire location.
2. Using the three lag screws (B) attach ceiling bracket (A) to a
structural member in the ceiling, centering the crossbar over the
outlet box (Figure 1). Lag screws have been supplied with
your fixture; however, different materials and/or construction
methods may require different fasteners. If in doubt, contact a
qualified electrician. Do not attach crossbar directly to outlet
box.
3. Attach canopy support cable (D) to mounting bracket using a
#8 screw (E). Temporarily suspend canopy using cable (Figure 2).
#8 screw (E) ships installed, it will need to be removed prior to
installation of the support cable (D).
Caution: The cable is intended to temporarily suspend the canopy to
help with fixture installation. Never depend on them to support
fixtures with glass installed.
4. Loosen cable gripper locks before trying to install cables.
Note: Support cable (F) will not be able to pass through the cable
gripper (G) unless the locks are loose.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Note: Support Cable also acts as Low Voltage Supply Cable.
(Figure 1)
(Figure 2)