Ampeg SVT-5 PRO - Manual (Page 9)

9
SVT-5 PRO Bass Amplifier
Rack Mounting
When mounting the SVT-5 PRO into a rack, the four
bottom feet should be removed to maintain the three
rack space height of the amplifier. Be sure to keep the
feet and their attachment bolts for future use. If the feet
are reinstalled, never use screws which will protrude
farther into the amplifier than the original hardware.
The rack must be a high quality enclosure capable of
securely supporting the weight of the amplifier. Tighten
the mounting screws securely through the amplifier’s
face plate, into the rack rails. Check the rack and
mounting screws occasionally to ensure a continually
safe and secure installation.
Troubleshooting
In the unlikely event that your SVT-5 PRO should malfunction, take a few minutes to troubleshoot it before you
call for service. You can save yourself time and money by doing it yourself, and often the cure for the problem is
something quite simple.
If the problem isn’t covered above, or if the steps lead you here, then contact your Ampeg dealer for service infor-
mation. Also, you should refer your amp for servicing if it gets dropped, has liquid spilled into it, or sustains damage
to its power cord (see page 3).
NO SOUND
LEDs LIGHT
POOR SOUND
Check bass, cables
Check speaker(s)
Replace speaker(s)
POOR SOUND
LEDs DON'T LIGHT
Check AC outlet
NO SOUND
NO HUM HUM
Listen for hum
NO CHANGE
SOUND OK
SOUND OK
POOR SOUND SOUND OK
SOUND OK
Check amp controls, check
for signal from bass
Check amp's power
cord, circuit breaker,
power switch Check house fusebox
or circuit breaker SPEAKER(S) OK,
POOR SOUND SPEAKER(S)
DEFECTIVE
Check speaker Unplug bass,
touch tip of cable
Speaker OK
Replace cable
NO CHANGE
SEE BELOW SEE BELOW
NO POWER OUTLET OK
OK