Hubbardton Forge 844015 - Manual

Installation Instructions
F12
For Rook Towel Bars 84-4010, 84-4012 & 84-4015
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24303
To Install
Component Parts
A Towel Bar
B Set Screw (2(
C Wall Mount Plate (2)
D Screws (4)
E Wall Anchors (4)
1. Remove wall mount plate (C) from the towel bar (A) by
loosening set screw (B) and sliding wall mount plate (C)
from fixture (A). Do this for both ends (Figure 1).
2. Hold first wall mount plate (C) in location it is to be
mounted. With a pencil, mark the location of the top
mounting hole in the wall mount plate (C) on the wall
behind.
3. Measure from the top marked hole the following distances.
84-4010 – 16”, 84-4012 – 24”, 84-4015 – 36” center to center.
4. If attaching directly to a framing member skip this step.
Put the wall mount plate down and drill 1/4" holes in the
locations marked on the wall if wall anchors (E) are to be
used. For holes using anchors, place the tapered end of the
anchors (E) into the holes and gently tap them flush to the
wall using a light weight hammer.
5. Install top screws (D) through wall mount plate (C) and
into each anchor. If anchors are not needed the screws
(D) can be installed directly to the wall.
6. Slip towel bar (A) onto wall mount plates (C). If center to
center distance is off slight alignment can be achieved by
loosening the screws and turning the wall mount plates
(C) until the center distance allows the towel bar (A) to
slide completely on the wall mount plates (C).
7. Slide towel bar (A) off enough to mark locations of lower holes.
8. Loosen and remove screw (D) installed in the tops of the wall mount
plates (C).
9. If attaching directly to a framing member skip this step. Put the wall mount plate down and drill 1/4" holes in the
locations marked on the wall if wall anchors (E) are to be used. For holes using anchors, place the tapered end of the
anchors (E) into the holes and gently tap them flush to the wall using a light weight hammer.
10. Install screws (D) through wall mount plate (C) and into each anchor. If anchors are not needed the screws (D) can
be installed directly to the wall.
11. Slip towel bar (A) onto wall mount plates (C) until against wall.
12. Tighten set screw (B) in both arms.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS PRODUCT PROPERLY MAY RESULT IN PERSONAL INJURY
OR PROPERTY DAMAGE. We recommend installation by a qualified individual trained in the building trade.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
(Figure 1)
(Figure 2)