Kantech KT-MOD-CAB - Manual (Page 2)

Telephone: 1 (450) 444-2030 • Toll free: 1-888-222-1560 • Fax: 1 (450) 444-2029 • Internet: www.kantech.com
Copyright © 2008 Tyco International Ltd. and its Respective Companies. All Rights Reserved • Specifications may change without notice.
Kantech and the Kantech logo are trademarks of Tyco International Ltd. and its Respective Companies.
2
KT-MOD-CAB
E XPANSION M ODULES C ABINET I NSTALL S HEET
DN1806-0809
5. Run a 41 cm (16 in) SPI cable, provided with
every module, between the other modules.
6. If external power is required for the expansion
modules, run the ground and power cables
together through a separate knockout than
in Step 4. Connect the external power supply
to the expansion module as per their
corresponding install sheet.
7. Check the external power jumper position on
the expansion modules.
8. Run and connect the inputs or outputs
together through a separate knockout than
in Step 6 to each expansion module as per
the corresponding install sheet.
Note: Make sure that you don’t exceed the
conduits capacity according to the
specifications and the local building code.
9. Install and connect the tamper switch to the
tamper switch terminals on the KT-400
controller.
10. Power up all the expansion modules and verify
communication with the KT-400 controller.
11. Install the cabinet door.
Example of KT-400 Controller Interconnection with Expansion Modules