Swiftech MCW462INTEL - Manual (Page 2)

Copyright Swiftech 2001 – All rights reserved – Last revision date: Feb 1, 2002
Rouchon Industries, Inc., dbA Swiftech – 1703 E. 28
th Street, Signal Hill, CA 90806 – Tel. 562-595-8009 – Fax 562-595-8769
E Mail: Swiftech @swiftnets.com – URL: http://www.swiftnets.com
Information subject to change without notice
Page 2
• Identify the mounting holes on the bracket for your
processor, as shown in the schematic below:
2"
2"
2"
2"
1 1/2“ screw
Spring
Crisscros
tightening
pattern
•
Install MCW462-U on the CPU. Orientation is important for bleeding purposes. Please look-up the critical bleeding instructions paragraph below
prior to installing the block on the CPU.
•
Gradually tighten the screws in a crisscross pattern until you feel that they reach the bottom of the standoff. A “finger-tight” lock is sufficient.
Over tightening may result in stripping the nylon hex nut. Conversely, adjustments such as tightening the screws only partially are strictly
prohibited. Such attempts will result in improper contact between the CPU core and the heat sink, and result in CPU overheating.
CRITICAL BLEEDING INSTRUCTIONS:
The following applies mostly to dual processor installations. Depending on the orientation of the socket, it is critical to observe the position in which
your water-block is oriented for bleeding purposes. Assuming that the computer is standing up, and that the water-block is facing you as shown in
Fig.1 and Fig 2. below, Fig. 1 shows the two positions in which the MCW462-U will bleed correctly, and Fig. 2 shows the two positions in which the
MCW462-U will not bleed.
Two solutions are available to bleed the water-block correctly:
1. Bleed the water-block prior to installing on the CPU. Simply rotate the block in the position shown in Fig. 1.
2. If you prefer to install the block first, then bleeding should be done with the computer laying down flat so that the Swiftech logo is facing
downwards, as shown in Fig. 3
C O R R E C T B L E E D N O B L E E D
Fig. 1 Fig. 2
C O R R E C T B L E E D
Inlet Outlet
Fig. 3
DISCLAIMER: Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products.