Swiftech MCW60 T User Manual
Page 3
2.
Mechanical Installation (all nVidia High-end GeForce and ATI Radeon using a four-hole fastening system)
Step 1
Apply the supplied thermal compound to the GPU,
peel-off the protective paper from the gasket, and then
insert the back-plate with its gasket thru the board.
Step 2
Remove the protective paper from the board gasket, and
push the gasket down (sticky side face down) the posts
until it mates with the board.
Step 3
Push the MCW60-T assembly down the posts until it mates
with the board gasket
Step 4
Place the spring, nylon tension limiter and thumbnuts on
each post.
Step 5
Gradually fasten the assembly with the provided thumbnuts
in a cross pattern, until you feel that the nylon tension
limiter is preventing the spring from compressing further.
Do not over tighten!
Mechanical installation is now complete!
Copyright Swiftech 2006 – All rights reserved – Last revision date: 5-15-06 – One or more Patents Pending
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:
[email protected] – URL:
http://www.swiftnets.com
- Information subject to change without notice