Swiftech H20 120 R3A User Manual
Swiftech Computer Accessories
Advertising
Table of contents
Document Outline
- Note \(1\) – Troubleshooting
- Note (2) - Starting the Power Supply when the motherboard is not connected
- Remove the existing heat sink
- Carefully clean the processor, using alcohol
- Install the 4 neoprene pads as shown figure 8. This step is only necessary if the processor core is exposed. If the chipset features a heat spreader (a large lid covering the entire area of the chipset), then the neoprene pads MUST not be installed.