Swiftech H20 80 User Manual
Swiftech Computer Accessories
Advertising
Table of contents
Document Outline
- Preamble
- Remove the existing heat sink
- Carefully clean the processor, using alcohol
- Install the 4 neoprene pads as shown figure 8. This steps is only necessary if the processor core is exposed. If the chipset features a heat spreader (a large lid covering the entire area of the chipset), then the neoprene pads MUST not be installed.
- Lightly coat the processor with the provided thermal compound. Only a paper-thin coat is necessary. It should be applied using preferably a razor blade, or a credit card, held between thumb and index at a 45( angle