APC Disk On-line Server NAS-2100 - Manual (Page 8)

Chapter 2 Installation of Disk On-line Server
2.1 Network Configuration
By factory default, Disk On-line Server will search the network via DHCP
(Dynamic Host Configuration Protocol) to detect IP address settings automatically.
If your network does not support DHCP protocol, Disk On-line Server will use the
default settings as below:
IP Address: 192.168.0.1
Subnet Mask: 255.255.255.0
When Disk On-line Server completes its boot-up process, the LCD panel will
display current IP address settings.
If your network does not support DHCP protocol, you must configure your Disk
On-line Server to proper LAN settings before using it for the first time. (If you
are not sure about the LAN settings, please contact your network administrator).
You can change the network settings of Disk On-line Server by the following ways:
1. Use the LCD panel to change the network settings. For more information,
please refer to Appendix A.
2. Use Quick Install Wizard in the companion CD to change the network settings.
For more information, please refer to Appendix C.
8