Audiovox SP-6CD - Manual (Page 4)

3
Never mount the unit near the fuel tank.
Secure the unit in place using four self-tapping screws
(M5 x 12).
SETTING THE ANTI-VIBRATION SPRINGS
This unit can be installed horizontally (suspended), vertically, and at a 45° angle. Once the installation position has been decided, it's
necessary to set the position of the built-in anti-vibration springs inside the unit. Please do this before performing the procedure. Vibration
may cause the disc to skip if the unit is used before properly setting the anti-vibration springs.
At the time of shipping, the built-in anti-vibration springs is set for horizontal installation "H".
There are built-in anti-vibration springs on both the left and right sides.
Set the anti-vibration springs position with a screwdriver before attaching the brackets.
For use when unit is installed horizontally or suspended:
Confirm that the built-in anti-vibration springs is set to position "H".
For use when unit is installed vertically:
The built-in anti-vibration springs should be set to position "V".
For use when unit is installed at a 45° angle:
The built-in anti-vibration springs should be set to position "45°".
Self-tapping screw (M5 x 12)
3
2
Determine the mounting location and drill four mounting holes.
Drill holes 4mm in
diameter.
1
Confirm that the built-in anti-vibration springs on both the
left and right sides are set to the horizontal installation
position "H".
Attach bracket (L) and bracket (R) using the hexagonal
bolts (M5 x 8).
PROCEDURE FOR HORIZONTAL INSTALLATION