Antec Quiet Computing Mini Skeleton-90 - Manual (Page 6)

5
H
ARDWARE
I
NSTALLATION
G
UIDE
This manual is not designed to cover CPU, RAM, or expansion card installation. Please consult your
motherboard user’s manual for specific mounting instructions and troubleshooting. Before proceeding,
check the manual for your CPU cooler to find out if there are steps you must take before installing the
motherboard.
2.1 R EMOVING /R EPLACING THE C OMPONENT T RAY
1.
With the rear of the case facing you, remove the thumbscrew at the left side of the Component
Tray.
2.
Pull back on the rear of the tray until it stops.
3.
To replace the tray, slide the tray back into the chassis from the rear until it locks into place,
then replace the thumbscrew on the left side of the Component Tray.
2.2
M
OTHERBOARD I NSTALLATION
Slide out the Component Tray from the Frame as detailed in section 2.1.
1.
Line up the motherboard with the standoff holes on the Motherboard Tray.
2.
Screw in the motherboard to the standoffs with the provided Phillips-head screws.
Replace the Component Tray in the Frame as detailed in section 2.1.
Note: You do NOT need to install an I/O panel for the Mini Skeleton. Your motherboard should
come with one. Keep it in a safe place. You will need it if you decide to move your
motherboard to a traditional case in future.