AKG Acoustics WMS 4000 - Manual (Page 21)

Volume
Sets the volume level of the headphone output
and matches the output level
to the mixer input level.
RF LED
Illuminates to indicate that RF signal is being
received. If the RF signal fails or the squelch
comes on, the RF LED will go out.
ON/OFF switch
with status LED.
Antennas
The swiveling antennas can be set to any
Case
Featuring an exceptionally light and com-
pact case, the PR 40 can be easily at-
tached to a belt, camera, pedalboard, etc.
using the belt clip or supplied Velcro strip.
Bottom panel charging contacts
The charging contacts allow you to charge
the batteries inside the PR 40 using the
optional CU 40 quick charger.
PR 40 portable receiver
D 880 M
Wireless and highly flexible
The TM 40 can be used with all Emotion and Tri-Power
Series microphones including the D 3700
M cardioid and
D 3800 M supercardioid dynamic microphones, the
C 5900 M supercardioid condenser microphone, the D 880 M
cardioid dynamic, and the C 900 M cardioid condenser
microphones. The right microphone for every budget and
every application on stage, easily convertible from hard-
wire to wireless.
C 900 M
D 3700 M D 3800 M C 5900 M
Choice of XLR modules
Several XLR connector modules are available for hardwire
operation. Gold plated contact pins ensure maximum audio
quality. XLR modules with or without an on/off switch are
available for the D 880
M , D 3700 M , and D 3800 M dynamic
microphones. The XLR module for the C 900 M condenser has
no switch, and the XLR module for the C 5900 M condenser
provides output level and bass cut switches. These modules
can convert a wireless microphone into a hardwire version
within seconds.
www.akg.com 21
AKG WMS 40 CUSTOMIZING
6052_WMSKern_engl.qxd 01.03.2006 11:52 Uhr Seite 21
angle.