Avocent PS/2 IP - Manual (Page 60)

8/16/32 PS/2 KVM over IP switch
60
Warning
This process is not reversible and might take some minutes. Make sure the PS/2
IP-KVM switch 's power supply will not be interrupted during the update process,
because this may cause an unusable card.
•
Thirdly, after the firmware has been stored, the panel will request you to reset the PS/2
IP-KVM switch manually. Half a minute after the reset, the PS/2 IP-KVM switch will run with
the new firmware version and should be accessible. However, you are requested to login
once again.
Warning
The three-stage firmware update process and complete consistency check are
making a mistake in updating the firmware almost impossible. However, only
experienced staff members or administrators should perform a firmware update.
Make sure the PS/2 IP-KVM switch 's power supply will not be interrupted!
6.5.4 Unit Reset
Figure 6-34. Unit Reset
To reset certain PS/2 IP-KVM switch functionality, click on the button “ Reset ” as displayed in Figure
6-34