Ultra Start KE-5 - Manual (Page 5)

TRANSMITTER PROGRAMMING
Passive / Active Arming Lock-Unlock-Lock-Unlock Passive Active
Passive / Active Locks Unlock-Trunk-Unlock-Trunk Passive Active
Ignition Aouto Door Locks Lock-Trunk-Lock-Trunk ON OFF
Door Lock Pulses Lock-Unlock-Trunk-Lock Three Second .75 Second
Double Pulse Unlock-Trunk-Unlock-Lock Double Pulse Single Pulse
Passive Warning Chirps Lock-Trunk-Unlock-Trunk ON OFF
Reset To Factory Defaults Trunk-Lock-Unlock-Trunk Three flashes Three Flashes
METHOD 1
1) Turn the ignition On-Off-On-Off-On-Off-On-Off. The park lights will flash
twice.
2) Press the Lock button on the transmitters to be programmed.
3) The park lights will flash once, each time a new transmitter is learned.
NOTE: The system can store a maximum of 3 transmitter codes in memory.
METHOD 2
1) Plug in the module. (Leave the ignition in the Off position).
2) Press the lock button on each of the transmitters to be programmed.
3) The park lights will flash once each time a new transmitter code is learned.
NOTE: Previous transmitters that are not programmed at this time will deleted.
System Reset
Reset To Factory Default Settings.
1) Make sure ignition is in the OFF position.
2) Turn the ignition key ON - leaving key in the ON position.
3) Press the transmitter buttons as follows. Trunk-Lock-Unlock-Trunk.
4) The system will respond by flashing the park lights three times*
*The system is now set to factory default settings.
REMOTE VEHICLE KEYLESS
INSTALL MANUAL
PAGE 5
Quick View Programming