Installation instructions – ASKO WL6511 User Manual

Page 27

Advertising
background image

26

Customer Care Center

1-800-898-1879

www.askousa.com

Level adjustment

1. The washer must be installed on a sturdy

and solid floor or the unit may make
considerable noise, vibrate and cause a
malfunction.

2. Adjust the level of washer using adjustable

legs.
• Please check if there is any gap between

the four adjustable legs and the floor.

• Turn the adjustable legs with the

enclosed wrench to adjust the level of
washer and make it sure that the
machine does not move when you push
on it.

• After the adjustment are finished, turn the

locking nuts up tightly so that the washer
maintains the adjustment.

3. Make sure that the washer does not move

when you press down on the four corners
of the machine.

There should be no rocking of the washer
and all of the adjustable legs should be sitting
firmly on the floor.

Connecting water supply hoses

• Water supply pressure must be between 4.5

and 145 PSI(30~1000 kPa).

• Do not cross-thread when connecting inlet

hoses to the inlet valves. If the water supply
pressure is more than 145 PSI, a pressure
reducing device should be installed.

• Two Sealing washers are supplied with the

water inlet hoses to prevent water leaks.

• Check for leakage of washing machine

connections by turning the tap completely

on.

• Periodically check the condition of the hose

and replace the hose if necessary.

• Make sure that there is no kink in the hose

and that it is not crushed.

• Make sure to connect the hot water valve on

the machine to the hot water valve on the

wall and that cold is connected to cold. The
hot water hose has a red stripe, the cold has
a blue stripe.

Repairs to the washing machine must only be
carried out by qualified personnel. Repairs
carried out by inexperienced persons may
cause injury or serious malfunctioning.
Contact our Customer Care Center.
Do not install your washing machine in a
room where temperatures below freezing
may occur.
Frozen hoses may burst under pressure. The
reliability of the electronic control unit may be
impaired at temperatures below the freezing
point. If the appliance is delivered in the
winter months and temperatures are below
freezing, store the washing machine at room
temperature for a few hours before putting it
into operation.

adjustable leg

Fixing Nut

Note!

Installation instructions

Advertising