Avalon Acoustics Sentinel - Manual (Page 18)

18
3.2 Upper Speaker Cabinet Set-up
CAUTION: Three people are required for the set-up procedure. To avoid injury,
do NOT attempt to set-up by oneself.
1. Lay the upper speaker on one side, using a blanket or other soft material to
avoid scratching the finish.
2. Install three Apex‘ couplers on the bottom of the cabinet by fastening the
threaded ends of the couplers into the cabinet inserts (see Figure 3.2). Lightly
tighten the couplers and insure that the base of the coupler contacts the
bottom of the recess.
3. Stand up the cabinet. Carefully route the integral wiring between the legs
of the cabinet base, thereby protecting the wiring harness from becoming
pinched.
WARNING: The wiring harnesses are fragile and can be easily damaged by
pinching them beneath the cabinet base.
4. Place the two supplied set-up blocks on top of the lower speaker cabinet,
taking care NOT to cover the sockets or wiring guide tubes, as shown in Figure
3.3. The set-up blocks prevent scratching of the lower speaker cabinet
during positioning and alignment.
Figure 3.3 – Placement of set-up blocks atop lower speaker cabinet. Do
NOT cover the receiving sockets or wiring tubes with the set-up blocks.