Troubleshooting – Indesit IWD61450 User Manual
Page 13

GB
13
Troubleshooting
Your washing machine could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure
that the problem cannot be not solved easily using the following list.
Problem:
The machine does not switch on.
The wash cycle does not start.
The machine does not fill with
water or “H2O” will flash on the
display.
The machine continuously fills with
water and continually drains away
or Water left in the drum
or Stuck on wash.
The machine does not drain or spin
or F05 error code in the display.
The machine does not heat or poor
wash results.
The programme takes too long
or The Display changes the
estimated ‘Time to End’ during the
programme.
The machine vibrates a lot during
the spin cycle.
Possible causes / Solutions:
w 8LIETTPMERGIMWRSXTPYKKIHMRXSXLIWSGOIXJYPP]SVRSXIRSYKLXSQEOIGSRXEGX
w 8LIVIMWRSTS[IVXSXLIWSGOIXSVXLIJYWILEWFPS[RMRXLIQEMRWTPYK
w 8LIHSSVMWRSXGPSWIHTVSTIVP]
w 8LI323**FYXXSRLEWRSXFIIRTVIWWIH
w 8LI78%684%97)FYXXSRLEWRSXFIIRTVIWWIH
w 8LI[EXIVXETLEWRSXFIIRXYVRIHSRXSEPPS[[EXIVXSJPS[MRXSXLIQEGLMRI
w %HIPE]IHWXEVXLEWFIIRWIX
w 8LI[EXIVMRPIXLSWIMWOMROIH
w 8LI[EXIVMRPIXLSWIMWRSXGSRRIGXIHXSXLI[EXIVWYTTP]
w 8LI[EXIVTVIWWYVIMWXSSPS[
w 8LI[EXIVXETLEWRSXFIIRXYVRIHSRXSEPPS[[EXIVXSJPS[MRXSXLIQEGLMRI
w 8LIVIMWRS[EXIVWYTTP]XSXLILSYWI
w 8LIMRPIXZEPZIJMPXIVMWFPSGOIH
w 8LI78%684%97)FYXXSRLEWRSXFIIRTVIWWIH
w 8LIXSTSJXLIHVEMRLSWIMWXSSPS[-XQYWXFIJMXXIHEXELIMKLXFIX[IIR
and 100 cm from the floor (see “Installation”).
w 8LIHVEMRLSWIMWGSRRIGXIHMRGSVVIGXP]XSXLIWMROXVETEPPS[MRK[EXIVXSVYR
into the machine, the drain hose must be positioned higher than the bottom of
the sink to prevent water flowing down the drain hose.
w 8LIIRHSJXLIHVEMRLSWILEWFIIRTYWLIHXSSJEVHS[RXLIWXERHTMTIXLI
D9 FVEGOIXWLSYPHFIJMXXIHQQJVSQXLIIRHSJXLIHVEMRLSWI
w 8LI4YQTJMPXIVMWFPSGOIH.
w 8LIHVEMRLSWIMWOMROIH(see “Installation”).
w 2I[-RWXEPPEXMSR8LIFPEROMRKGETSVWTMKSXLEWRSXFIIRVIQSZIHMJ
connected under a sink.
w 8LIHVEMRLSWISVWMROXVETMWFPSGOIH.
w 8LI[EWLG]GPIHSIWRSXMRGPYHIHVEMRMRKWSQI[EWLG]GPIWVIUYMVIXLIHVEMR
phase to be started manually.
w 8LID7TMR7TIIH WIPIGXSVORSFMWMRXLIl
” position.
w 8LID8IQTIVEXYVI WIPIGXSVORSFMWMRXLIl ” position.
w 4VSKVEQQIXMQIW[MPPZEV]HYIXS[EXIVTVIWWYVIXLIMRGSQMRK[EXIVXIQTIVE-
ture and if the wash load goes out of balance. This will increase the programme
XMQIWEGGSVHMRKP]WIID8LIQEGLMRI[SRXWTMRTVSTIVP]
FIPS[.
w 8LIJIIXLEZIRSXFIIREHNYWXIHIREFPMRKXLIQEGLMRIXSVSGO.
w 2I[-RWXEPPEXMSR)MXLIVXLI8VERWMX&SPXWMRGPYHMRKXLITPEWXMGWTEGIVWSVXLI
Polystyrene Packaging have not been removed when installing the machine.
w 8LIQEGLMRIMWXVETTIHFIX[IIRGEFMRIXWERHSV[EPPW.
w 8LIPSEHMWMREWPMKLXSYXSJFEPERGIGSRHMXMSRERHQEGLMRIMWWTMRRMRKFYXEX
a lower speed.