Indesit FIMU23WHS - Manual (Page 21)

GB
21
Care and Cleaning
Take particular care not to damage the inner
surface of the door inner glass that is coated with
a heat reflective layer. Do not use scouring pads,
or abrasive powder, which will scratch the glass.
Ensure that the glass panel is not subjected to
any sharp mechanical blows.
Stubborn stains can be removed by using a fine
steel wool pad. For slight soiling the inner glass
panel may be cleaned, while still warm, without
removing it from the door. After cleaning, rinse and
dry with a soft cloth.
CLEANING THE DOORS
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop
down doors, except take care to support the
weight of the inner glass when removing and
refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and unscrew the two screws
securing the glass panel so that the securing
brackets can be turned. There is no need to remove
the screws completely.
2. Turn the brackets so that
the glass can be
removed and cleaned at
the sink (Fig. 1.).
3. The inside of the outer door glass can now be
cleaned while still fitted to the cooker.
NEVER OPERATE THE COOKER
WITHOUT THE INNER DOOR GLASS IN
POSITION.
Refit the door inner glass as follows.
1. NOTE: The inner door glass has a special reflective
coating on one side. Replace the door inner glass
so that the statement: "IMPORTANT THIS FACE
TOWARDS THE OVEN"
can be read from the inner
side of the door.
2. Turn the two securing
brackets back to their
original position to retain
the glass and tighten the
screws (Fig. 2.)