Indesit IWME-106-(EU) - Manual (Page 25)

25
GB
Personalisations
Setting the temperature
Turn the TEMPERATURE knob to set the wash temperature (see Programme table).
The temperature can be lowered, or even set to a cold wash ( ).
Setting the spin speed
Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes
Maximum spin speed
Cottone 1000 rpm
Synthetics 800 rpm
Wool 800 rpm
Silk no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol .
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed for each
programme.
Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by conti-
nuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set
frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.
Option Effect Comments Enabled with
programmes:
Delay Timer
Delays the start of the
wash by up to 9 hours.
Pess the button repeatedly until the LED corresponding to the
desired delay is turned on. The fifth time the button is pressed, the
function will be disabled.
N.B.: Once you have pressed the Start/Reset button, the delay
can only be decreased if you wish to modify it.
All
Bleaching
Bleaching cycle de-
signed to remove the
toughest stains.
Please remember to pour the bleach into extra compartment 4
(see page 26).
This option is incompatible with the EASY IRON option.
2, 3, 4, , ,
8 and
Rinse cycle.
Easy iron
By selecting this function,
the wash and spin cycles
will be modified in order
to reduce the formation
of creases. At the end
of the cycle the washing
machine will perform slow
rotations of the drum. To drain the water so that the laundry may be removed, press
the START/PAUSE button.
This option is incompatible with the BLEACHING option.
1, 2, 3, 4, ,
, 8, 9, 10, 11.
Extra Rinse
Increases the efficiency
of the rinse.
Recommended when the appliance has a full load or with large
quantities of detergent.
1, 2, 3, 4, ,
, 7, 8, 9, 10,
11, 13, 14, and
Rinse cycle.