Indesit PWDE-81473-W-(EU) User Manual

Page 63

Advertising
background image

GB

63

Connecting the drain hose

Connect the drain

hose, without

bending it, to a drain

duct or a wall drain

situated between 65

and 100 cm from the

floor;

alternatively, placed

it over the edge

of a basin, sink or

tub, fastening the

duct supplied to

the tap (see figure).

The free end of the

hose should not be

underwater.

! We advise against the use of hose

extensions; if it is absolutely necessary, the

extension must have the same diameter as

the original hose and must not exceed 150

cm in length.

Electrical connections

Before plugging the appliance into the

electricity socket, make sure that:

• the socket is earthed and complies with all

applicable laws;

• the socket is able to withstand the

maximum power load of the appliance as

indicated in the Technical data table (see

opposite);

• the power supply voltage falls within the

values indicated in the Technical data table

(see opposite);

• the socket is compatible with the plug of the

washer-dryer. If this is not the case, replace

the socket or the plug.

! The washer-dryer must not be installed

outdoors, even in covered areas. It is

extremely dangerous to leave the appliance

exposed to rain, storms and other weather

conditions.

! When the washer-dryer has been installed, the

electricity socket must remain within easy reach.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable must only be

replaced by authorised technicians.

Warning! The company shall not be held

responsible in the event that these standards

are not observed.

The first wash cycle

Once the appliance has been installed, and

before you use it for the first time, run a wash

cycle with detergent and no laundry, using

wash cycle number 2

.

65 - 100 cm

Technical data

Model

PWDE 81473 W

Dimensions

width 59.5 cm

height 85 cm

depth 60 cm

Capacity

from 1 to 8 kg for wash

programme

from 1 to 6 kg for the drying

programme

Electrical

connections

please refer to the technical

data plate fixed to the machine

Water con-

nections

maximum pressure

1 MPa (10 bar)

minimum pressure

0.05 MPa (0.5 bar)

drum capacity 62 litres

Spin speed

up to 1400 rotations per

minute

Energy ra-

ted

programmes

according to

regulation

EN 50229

wash: programme 2; tem-

perature 60°C; using a load

of 8 kg.

drying: the smaller load

must be dried by selecting

the “A1” (IRON) dryness le-

vel. The load must consist of

2 sheets, 1 pillowcase and

1 hand towel; the remainder

of the load must be dried by

selecting the “A4” (EXTRA)

dryness level.

This appliance conforms to

the following EC Directives:

- 2004/108/EC (Electroma-

gnetic Compatibility)

- 2006/95/EC (Low Voltage)

- 2002/96/EC

Advertising