Indesit IHF-9.5-A-M-IX - Manual (Page 38)

38
GB
GLASS controls
Models with mechanical keypad
IHF 6.5 A M IX - IHF 9.5 A M IX
IHF 6.5F A M IX - IHC 9.5F A M IX
IHC 9.5 A M IX - IHC 6.5F A M IX
T1 T2 T3 T4 T5
T1 Motor reset
Pressing the button while the hood is in operation turns it
OFF.
T2 Speed 1
Pressing the button sets the hood to speed 1.
T3 Speed 2
Pressing the button sets the hood to speed 2.
T4 Speed 3
Pressing the button sets the hood to speed 3.
T5 Lights ON/OFF
Maintenance and care
Caution! Before cleaning or servicing the unit,
disconnect it from the mains by pulling the power plug
or disconnecting the main circuit breaker.
First cleaning
• Remove the protective film
• Clean with a damp sponge and a little neutral soap
• Rinse off with a damp cloth
• Dry with a soft cloth; if the hood is stainless steel, dry
along the metal's grain
Periodic cleaning
The hood must be cleaned frequently (at least as often as
you service the grease filter), inside and out. Use a damp
cloth and a neutral liquid detergent with lukewarm water.
Do not use abrasive or corrosive products.
Warning:
Failure to observe the hood cleaning and filter
cleaning/replacement instructions can result in fires. Follow
the instructions carefully. The manufacturer is not liable for
any damage to the motor or fires caused by incorrect care
or failure to follow the above instructions.
Servicing the grease filter (A)
A
The grease filter retains the
particles of grease produced
during cooking; it must be
cleaned at least once a month
w i t h a n o n - a g g r e s s i v e
detergent, either by hand or
with a low temperature, short
dishwasher cycle.
To extract the grease filter,
pull the spring loaded handle.
If washed in a dishwasher, the metal filter may change
colour, but this does not affect its performance.
Servicing the charcoal filter (B)
The charcoal filter retains unpleasant cooking odours.
The filter saturates after a variable time, depending on the
type of cooking and how often the grease filter is cleaned.
The cartridge must be replaced at least once every twenty
months.
This filter can NOT be washed or regenerated
B
Disassembly: Remove the
activated-carbon filter by
pressing the two front levers
which secure it to the hood.
B
Assembly: Secure the
activated-carbon filter first in
the back using the hood's
metal tabs and then in the
front by pressing the two
levers.