ROTHENBERGER ROTIGER VARIO Electronic - Manual (Page 14)

13 ENGLISH
Tool use and care
Use clamps or other practical way to secure
and support the work piece to a stable
platform. Holding the work by hand or against
your body is unstable and may lead to loss of
control.
Do not force tool. Use the correct tool for your
application. The correct tool will do the job better
and safer at the rate for which it is designed.
Do not use tool if switch does not turn it on or
off. Any tool that cannot be controlled with the
switch is dangerous and must be repaired.
Disconnect the plug from the power source
before making any adjustments, changing
accessories, or storing the tool. Such preventive
safety measures reduce the risk of starting the tool
accidentally.
Store idle tools out of reach of children and
do not allow persons unfamiliar with the
power tool or these instructions to operate
the power tool. Tools are dangerous in the hands
of untrained users.
Maintain tools with care. Keep cutting tools
sharp and clean. Properly maintained tools, with
sharp cutting edges are less likely to bind and are
easier to control.
Check for misalignment or binding of moving
parts, breakage of parts, and any other
condition that may affect the tools operation.
If damaged, have the tool serviced before using.
Many accidents are caused by poorly maintained
tools.
Use the power tool, accessories and blades
etc., in accordance with these instructions and
in the manner intended for the particular type
of power tool, taking into account the
working conditions and the work to be
performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
Service
Have your tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
-WARNING- To reduce the risk of injury, user
must read instruction manual.
Symbols used in this manual
V ......... volts
A ......... amperes
Hz ....... hertz
W ........ watt
~ ......... alternating current
n
0 ..............
no load speed
/min..... revolutions or reciprocation per minute
... class II tool