A.J. Antunes & Co MS-355 9100486 - Manual (Page 7)

MIRACLE STEAMER
7 P/N 1010456 Rev. C 08/12
A.J. Antunes & Co.
THIS UNIT IS DESIGNED TO
OPERATE ON 208 VOLTS
ONLY. APPLICATION WITH ANY
OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL
WARRANTY. PLEASE CHECK
YOUR LINE VOLTAGE BEFORE
INSERTING THIS PLUG INTO THE
RECEPTACLE.
WARNING WARNING
THIS UNIT IS DESIGNED TO
OPERATE ON 120 VOLTS
ONLY. APPLICATION WITH ANY
OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL
WARRANTY. PLEASE CHECK
YOUR LINE VOLTAGE BEFORE
INSERTING THIS PLUG INTO THE
RECEPTACLE.
WARNING WARNING
120 VAC
ONLY
208 VAC
ONLY
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS UNIT IS DESIGNED TO
OPERATE ON 220-240 VOLTS
ONLY. APPLICATION WITH ANY
OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL
WARRANTY. PLEASE CHECK
YOUR LINE VOLTAGE BEFORE
INSERTING THIS PLUG INTO THE
RECEPTACLE.
WARNING WARNING
220-240
VAC ONLY
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
CAUTION
All electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
Plumbing
NOTE: Miracle Steamer models are designed to
use cold tap water. Distilled water may be used to
reduce calcium/mineral deposit buildup and reduce
maintenance costs.
The MS-355 models have a self-contained water tank.
To fill the self-contained water tank:
1. Open the sliding tank drawer on the side of the
unit (Figure 2).
NOTE: Make sure filter inside tank is installed
properly.
2. Pour in
cold tap water. The tank will hold
approximately 3 quarts (2.81 liters).
Do NOT overfill the unit water tank. Only fill the
tank to 90% full.
3. Close the sliding tank drawer.
CAUTION
This equipment is to be installed to comply with
the basic plumbing code of the Building Officials
and Code Administrators, Inc. (BOCA) and the
Food Service Sanitation Manual of the Food and
Drug Administration (FDA).
INSTALLATION (continued)
READY
ADD WATER
Figure 2. Filling Water Tank
Indicator Light (Low water)
Tank
CAUTION
Be sure to follow all safeguards and precautions
in the Important Safety Instructions section of this
manual.
Electrical
1. Set the unit on a sturdy, level table or work surface.
2. Ensure that the line voltage corresponds to the
stated voltage on the units specification label and
power cord warning tag. If you are unsure of
your Line Voltage, contact an electrician.
3. Connect the unit to the power supply.