A.J. Antunes & Co HDH-4 9300130 - Manual (Page 7)

7 P/N 1010736 Rev. G 05/14
OPERATING
INSTRUCTIONS
1. Remove, or slide open, the top cover.
2. Pour 7 quarts (5.6 liters) of clean tap
water into the water pan (Figure 2).
There is a “FULL” line inscribed on the
inside of the pan.
NOTE: Using hot water will shorten the
time it takes for the unit to reach
operating temperature.
3. Load the unit with product and
install or close the cover.
4. Turn the rocker switch (power on/
off) to the ON position.
5. Turn the thermostat knob fully clock-
wise (maximum heat) and indicator
light will come on. When tempera-
ture setting is reached, heat indicator
light will go out.
6. The water will begin to steam in ap-
proximately 30-40 minutes (or soon-
er if hot water was used initially). The
product will be thoroughly heated
and ready to serve 15-20 minutes
after steaming begins.
7. When the product is ready to be
served, turn the thermostat knob to
180°F (82°C) to maintain the food at
serving temperature.
NOTE: Volume, preference and experi-
ence will determine what tem-
perature setting is best for your
operation.
8. To remove product from the unit,
lift one side of the top cover and let
it rest in the upright position. Using
tongs or a similar utensil, lift the
product out and close the cover.
NOTE: Keep cover closed unless adding
or removing product.
CAUTION
Do NOT pour water hotter than 120°F
(48°C) into a cold unit. Resulting
steam can cause personal injury.
WARNING
Keep face away from cover and opening
when removing product from unit. Steam
can escape and cause personal injury.
THERMOSTAT CONTROL
HI-LIMIT RESET SWITCH
ROCKER SWITCH
“HEATER ON”
INDICATOR LIGHT
For MFg. No. 9300132
the power cord is located
on the left side of the
unit. See Note on Page
11.
Figure 2. Filling Water Tray
Figure 3. Controls
Hi-Limit Reset Button
A hi-limit thermostat will turn off electrical
power to the heater and control circuits
if the unit overheats due to running low
on water. To reset this thermostat, allow
sufficient time (10-15 minutes) for the unit
to cool down, then press the Hi-Limit Reset
Button located on the front of the unit
(Figure 3).
If the unit requires continuous resetting,
contact your Roundup Authorized Service
Agency.