AccuTemp EVOLUTION GAS STEAMER - Manual (Page 28)

MP4010-1003 EVOLUTION GAS STEAMER
22
TROUBLESHOOTING
Steamer won’t come on
Verify that the steamer is plugged into the proper outlet. •
Verify that the breaker is turned on. •
If the “high Water” warning light is on open the drain valve and drain the water until the light •
goes out.
Verify that the float is in place.
•
Steamer doesn’t heat
If the operator’s display doesn’t light up, See section“ Steamer won’t come on”. •
Verify the steamer door is closed, as the heat won’t turn on if the door is open. •
Steam comes out the door
Verify that the door is completely closed and latched. •
Wait a minute to see if it stops. After the steamer refills with water it is normal for some •
steam to come out the door for a brief amount of time, usually less than one minute.
Steamer Temperature is low
When the steamer automatically refills the fresh water-cools the steamer off for a brief •
period of time, but the steamer will reheat quickly.
If these don’t solve your problem contact our Technical Service Department.
Phone - 800.480.0415 or 260.469.3040 •
Email - • [email protected]
Web site - • www.accutemp.net