elektraLite Warm White Dazer - Manual (Page 3)

3. General Guidelines.
The Elektralite WW Dazer is a lighting fixture for professional use on stages, in churches, theatres,
etc.
The Elektralite WW Dazer should only be operated at between 120 to 240 volts and only indoors.
The Elektralite WW Dazer should not be operated 24/7 (24 hours a day; 7 days a week). The
Elektralite WW Dazer needs operation breaks to ensure that it will work for a long time without
problems. Please do not shake the Elektralite WW Dazer and avoid using brute force when installing
or operating it.
When choosing the location to install the Elektralite WW Dazer, please make sure that it is not
exposed to extreme heat, moisture or dust. The minimum distance between the Elektralite WW Dazer
and the illuminated surface must be more than 3 feet.
Always mount the Elektralite WW Dazer with an appropriate safety cable/chain.
Operate the Elektralite WW Dazer only when you are familiar with the features on the fixture. Do not
permit operation by persons not qualified to operate it.
All modifications to the Elektralite WW Dazer will invalidate the warranty. There are absolutely no
exceptions.
If Elektralite WW Dazer is operated in any way different to the one described in this manual, the
Elektralite WW Dazer maybe damaged and the guarantee will be void.
4. Installation
Please ensure that the Elektralite WW Dazer is hung using the appropriate "C" clamp or half
cheeseboro. A safety chain or cable should also be used as a secondary point of holding the fixture in
case the clamp comes loose.
Never hang the fixture without a safety chain or cable . Make sure the
Gel frame (Gel holder) is clipped into position correctly and cannot come loose.
If you are not qualified or have any doubts about hanging the Elektralite WW Dazer then do NOT hang
it.
Do not clamp the cable to the U bracket or clamp. That is not a secondary safety point.
A secondary safety point is any point that will adequately hold the Elektralite WW Dazer if the "C"
clamp or half cheesboro fails. Then the safety cable would be the backup and stop the fixture from
falling to the ground. So do NOT fix the safety to the same place that the "C"clamp is attached.