elektraLite Dazer Theatrical White - Manual (Page 3)

3. General Guidelines.
The Elektralite Theatrical White Dazer is a lighting fixture for professional use on stages, in churches, theatres, etc.
The Elektralite Theatrical White Dazer should only be operated at between 120 to 240 volts and only indoors.
The Elektralite Theatrical White Dazer should not be operated 24/7 (24 hours a day; 7 days a week). The Elektralite
Theatrical White Dazer needs operation breaks to ensure that it will work for a long time without problems. Please do
not shake the Elektralite Theatrical White Dazer and avoid using brute force when installing or operating it.
When choosing the location to install the Elektralite Theatrical White Dazer, please make sure that it is not exposed
to extreme heat, moisture or dust. The minimum distance between the Elektralite Theatrical White Dazer and the
illuminated surface must be more than 3 feet.
Always mount the Elektralite Theatrical White Dazer with an appropriate safety cable/chain.
Operate the Elektralite Theatrical White Dazer only when you are familiar with the features on the fixture. Do not
permit operation by persons not qualified to operate it.
All modifications to the Elektralite Theatrical White Dazer will invalidate the warranty. There are absolutely no
exceptions.
If Elektralite Theatrical White Dazer is operated in any way different to the one described in this manual, the
Elektralite Theatrical White Dazer maybe damaged and the guarantee will be void.
4. Installation
Please ensure that the Elektralite Theatrical White Dazer is hung using the appropriate "C" clamp or half cheeseboro.
A safety chain or cable should also be used as a secondary point of holding the fixture in case the clamp comes loose.
Never hang the fixture without a safety chain or cable . Make sure the Gel frame (Gel holder) is clipped into position
correctly and cannot come loose.
If you are not qualified or have any doubts about hanging the Elektralite Theatrical White Dazer then do NOT hang it.
Do not clamp the cable to the U bracket or clamp. That is not a secondary safety point.
A secondary safety point is any point that will adequately hold the Elektralite Theatrical White Dazer if the "C" clamp
or half cheesboro fails. Then the safety cable would be the backup and stop the fixture from falling to the ground. So do
NOT fix the safety to the same place that the "C"clamp is attached.