elektraLite Moving Yoke 120v Spot - Manual (Page 9)

- ８ - MY575 SPOT
Main functions
- Main menu 0
1. Press [ENTER] for 3 seconds to enter the main menu "MODE" (display flashing)
2. Press [ENTER] and select "ADDR", “RUN” or "DISP" by pressing the [UP] button.
3. Press [ENTER] to select the desired sub menu.
- DMX address setting, Slave setting
- DMX address setting
With this function, you can adjust the desired DMX-address via the Display Panel.
1. Select “VALU” by pressing the [UP] button.
2. Press [ENTER], adjust the DMX address by pressing the [UP] or the [DN].
3. Press [ENTER] to confirm.
4. Press [EXIT/DN] to return to main menu.
- Slave setting
With this function, you can define the device as slave.
1. Select “SLAV” by pressing the [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t.
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] to return to the main menu.
- Program Run, Master setting
With the function "RUN", you can run the internal program. You can set the number of steps under Step. You
can edit the individual scenes under Edit. You can run the individual scenes either automatically (AUTO), i.e.
with the adjusted Step-Time or sound-controlled (SOUN). The selection "ALON" means Stand Alone-mode and
"MAST" that the device is defined as master.