Ferguson Ariva 252Combo - Manual (Page 19)

11.3 Antenna setup
This menu is used to set detailed operating parameters for previously selected satellites,
depending on your antenna system. Select a satellite by pressing the left/right arrow keys.
Only satellites marked on the list of satellites will be available. Now select the converter type
(usually, you do not have to change this option and may leave it set to "universal"). Next, if
you have a switch for more than one satellite, set the required port. Depending on the type of
switch, these will be options for DiSEqC 1.0 or DiSEqC 1.1 (do not activate these two options
simultaneously).
The correct setting of the antenna is indicated by bars presenting the strength and quality of
the signal. Both should indicate more than 80% for channel reception to be free of interference.
In order to check the strength and quality settings, use the "transponder" option in order to
alter the frequency and verify whether each V and H polarization is operative.
Confirm the settings by pressing BACK.
If as the antenna connection you have selected: antenna with positioner, the antenna settings
menu will have a different appearance. Two operating standards will be available for the
positioner: USALS or DiSEqC 1.2. We recommend using USALS positioners, for which only the
correct longitude and latitude must be given.
19