Setting the clock – Audiovox Prestige P963ESP User Manual

Page 8

Advertising
background image

128-6981

8 of 20

-8-

NOTES ON USE OF FRONT PANEL

1. Make sure the front panel is oriented correctly when sliding it

into the front mounting plate, as it cannot be attached when
up-side down. Use moderate pressure to fully seat the panel
into position.

2. To verify correct panel installation, swing the panel assembly up

into position until it locks easily into place. If any resistance is
encountered, re-check panel orientation in chassis mounting
plate.

NOTE: When the faceplate is in the upright position, press the

release button to lower the faceplate away from the radio
chassis.

3. When taking the front panel with you, please use the supplied

carrying case to protect the panel from dirt and damage. Make
sure there is no dust or dirt on the electrical terminals on the back
of the panel as this could cause intermittent operation or other
malfunctions.

SETTING THE CLOCK

1. Switch the vehicle ignition and radio on.

2. Momentarily press the Time/Frequency (T/F) Select button

dl

so that the time is shown on the display panel.

3. Press and hold the Time/Frequency button until the time display begins flashing. While the display is still

flashing, press the Up Tuning

(

)

button to adjust the hours and then the Down Tuning

(

)

button

to adjust the minutes to the correct time.

4. Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and the display

will return to the normal indication.

dp

INFRARED (IR) WINDOW

This window covers the remote IR sensor which responds to the IR
signal from the remote control for selection of radio functions.

FRONT PANEL

MOUNTING PLATE
GUIDE (2 PLACES)

PANEL
MOUNTING
PLATE

RESET BUTTON
(32)

THEFT DETERRENT
LED (31)

DISC SLOT
(20)

CD EJECT

BUTTON

(28)

Advertising