Ferguson RCU650 - Manual (Page 4)

English
• The Manual Search is automatically terminated if no entry occurs during 30 seconds
period.
• Manual search mode, search forward from the current code.
Learning Function
The learning function is used to extend the pre-programmed codes. The standard code list
already provides you with the most important functions, but it is possible to add a few
additional functions. A fully functional original remote control is required for learning
programming.
Please use fresh batteries for both the Learning Remote Control and the Original Remote
Control.
1. Press down and hold the device button which you wanted to learn
(e.g. BD player), and press find button at the same time, when
LED turns on then release the both pressed keys, now remote
control is in learning mode for BD codes.
2. Point the IR transmitter of the original remote control remotes face
to the IR receiver of your RCU650 remote by approximately 30
mm apart. Keep two remotes at the same straight line to make the
learning process more accurate.
3. Press and release the target button on your RCU650 remote
control which you want to learn (e.g. info), the LED starts to flash.
4. Press the one button (For example, info button) from your original
remote control, when you see LED on new universal remote
control flashes three times and stop, it means RCU650 has
accepted new code and now you can start to learn another new
code from original remote.
5. Repeat step 3 to 4 to learn another code from original remote
control.
6. When you finish learning all buttons you want to have, press find
button to store all commands you have learnt from original remote and exit from
Learning remote.