HID Wiegand PINPad Rev C Installation Guide - Manual (Page 5)

PINpad 8-bit Wiegand Reader, 7393760, rev E
Figure 3 Base Unit Dimensions
Troubleshooting
To confirm that the unit is operating properly:
1. Attach an earth ground point to the Tan wire protruding from the base unit.
2. Attach +5 to 12 VDC to the red line in the cable.
3. Attach a DC Ground point to the Black line in the cable.
4. Monitor the current draw and confirm that the current is not greater than 150mA.
If the current draw exceeds 150 mA remove power immediately and call HID
Tech Support.
5. Confirm the Red LED is illuminated. If it is not, remove power and call
HID Tech Support.
6. Connect the Brown wire in the cable to DC ground and confirm that the LED
turns green. If it does, the unit should be working properly. If you are still having
problems call HID Tech Support.
October 10, 2007 © 2007 HID Global Corporation. All rights reserved. Page 5 of 6