HID VertX Vx00 Installation Guide - Manual (Page 9)

November 2011 Page 9 of 10
© 2003 - 2011 HID Global Corporation. All rights reserved.
VertX V100, V200 and V300 Installation Guide
Any input can be configured as NO or NC, as well as unsupervised or supervised. They can be configured
for supervisory resistors of 1K – 6K Ohm. The setup of supervised inputs should be done during
configuration of the VertX devices via the host
Example: Input 1, V1000 is: P14 Pin1 is + and Pin 2 is -.
Input Number V100 V200 V300
1 P2 Pins 1/2 Door Monitor P1 Pins 1/2 P6 Pins 2/1
2 P2 Pins 3/4 REX input P1 Pins 3/4 P3 Pins 1/2
3 P5 Pins 4/3 Door Monitor P1 Pins 5/6 P7 Pins 8/7 Tamper
4 P5 Pins 2/1 Rex Input P1 Pins 7/8 P7 Pins 6/5 AC Fail
5 P7 Pins 8/7 Tamper P1 Pins 9/10 P7 Pins 4/3 Batt Fail
6 P7 Pins 6/5 AC Fail P2 Pins 1/2
7 P7 Pins 4/3 Batt Fail P2 Pins 3/4
8 P2 Pins 5/6
9 P4 Pins 10/9
10 P4 Pins 8/7
11 P4 Pins 6/5
12 P4 Pins 4/3
13 P4 Pins 2/1
14 P5 Pins 6/5
15 P5 Pins 4/3
16 P5 Pins 2/1
17 P7 Pins 8/7 Tamper
18 P7 Pins 6/5 AC Fail
19 P7 Pins 4/3 Batt Fail
Supervised inputs can be configured for:
Except for the door monitor, all other
inputs default to NO, unsupervised: