Testing the installation – HID Microsoft UAG and 4TRESS AS User Manual
Page 46
ActivIdentity 4TRESS and Microsoft Unified Access Gateway | Integration Handbook
P 46
External Use | July 17, 2012 | © 2012 ActivIdentity
5.0
Testing the Installation
When all of the above sections have been completed, the installation can be tested. To do this, an attempt to
authenticate the test user previously used will be made to the UAG portal. Make sure the certificate of the UAG
server is trusted.
1. From the machine where the PC Soft Token was installed, launch a web browser and go to the UAG URL
defined in step 4 of section 4.3 above, e.g.
2. When asked to trust the site
with regards to pop-up windows,
press Yes
3. Next, the UAG portal will attempt to install some software. Press Install to go ahead with the installation
as these components are needed for full site operability
Note: After installing the components, the browser may have to be restarted.