HID ProxCard Handling Guide - Manual (Page 4)

.125"
.317 cm
.450"
1.143 cm
.125"
.317 cm
.450"
1.143 cm
.125"
.317 cm
PRINTING INSTRUCTIONS (Cont'd.)
The drawing below outlines the recommended print area on
the card. Some printers are capable of full-bleed or
edge-to-edge printing. HID recommends that you run some
test cards on your printer before designing your graphics for
edge-to-edge printing. Also, most printer manufacturers
discourage printing on cards which are pre slot punched,
as the slot edge may tear the printer ribbon or interfere with
the end-of-card sensor and stop the printing process.
Print your cards first, then slot punch them. If your cards are
already punched, do not print in the area near the slot (dark
hatched area in diagram below).
We hope these suggestions will help you
successfully print on your HID cards.
HID Corporation, Irvine
9292 Jeronimo Road
Irvine, CA 92618-1905
Tel: (800) 237-7769
Fax: (949) 598-1690
www.HIDCorp.com
HID Corporation, CT
333 State Street
North Haven, CT 06473
Tel: (800) 243-2563
Fax: (203) 407-5990
www.HIDCorp.com
Page 4
PRINT AREA
(unless card is slot punched)
Do NOT print this area if card is slotted on this edge.
Do NOT print this area if card is slotted on this edge.