Karcher Brush cleaning devices and spray extraction devices - Manual (Page 7)

– 1
Please read and comply with
these safety instructions prior
to the initial operation of your appliance.
Retain these safety instructions for use for
future reference or for subsequent posses-
sors.
– Please read the operating instructions
for your machine before using it, and
pay particular attention to the following
safety instructions.
– Warning and information plates on the
machine provide important directions
for safe operation.
– Apart from the notes contained herein
the general safety provisions and rules
for the prevention of accidents of the
legislator must be observed.
– Keep packaging films away from chil-
dren, there is a risk of suffocation!
ƽ
Danger
Immediate danger that can cause severe
injury or even death.
ṇ
Warning
Possible hazardous situation that could
lead to severe injury or even death.
ṇ
Caution
Pointer to a possibly dangerous situation,
which can lead to minor injuries.
Notice
Pointer to a possibly dangerous situation,
which can lead to property damage.
ƽ
Danger
– The voltage indicated on the type plate
must correspond to the voltage of the
electrical source.
– Safety class I - Appliances may only be
connected to sockets with proper earth-
ing.
– While working with fluids (such as de-
tergents), we recommend the use of a
safe socket with overcurrent protection
switch (max. 30 mA).
– Please use the mains cable prescribed
by the manufacturer; the same is also
applicable when you replace the ca-
bles. See Operating Instructions Manu-
al for Order Number and Type.
– Check the power cord with mains plug
for damage before every use. If the
power cord is damaged, please arrange
immediately for the exchange by an au-
thorized customer service or a skilled
electrician.
– The appliance may only be connected
to an electrical supply which has been
installed by an electrician in accordance
with IEC 60364.
– Never touch the mains plug with wet
hands.
– Make sure that the power cord or exten-
sion cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the cable from heat, oil, and
sharp edges.
– The power cord must be checked regu-
larly for damages, such as cracks or ag-
ing. If damage is found, the cable must
be replaced before further use.
– If couplings of the power cord or exten-
sion cable are replace the splash pro-
tection and the mechanical tightness
must be ensured.
– Do not clean the appliance with a water
hose or high-pressure water jet (danger
of short circuits or other damage).
Notice
– Operating procedures create short term
power sinkings.
– During unfavorable net conditions other
devices might be disturbed.
– With a net impedance lower then 0,15
Ohm no disturbances are to be expect-
ed.
Safety instructions for brush cleaning devices and spray
extraction devices
Danger or hazard levels
Power connection
7 EN