Installation, Procedure for horizontal installation – Audiovox ACC40 User Manual

Page 4

Advertising
background image

Drill holes 1/8" (4mm) in diameter.

PROCEDURE FOR HORIZONTAL INSTALLATION

1

2

3

Bracket

Attach a mounting bracket to each side of the unit, using the
4 hex head bolts with washer base.

Determine the mounting location, and drill four mounting
holes.

Secure the unit in place, using four large self-tapping Phillips
head screws.
Use RTV (silicone sealer) on screw threads or around
the holes to prevent moisture intrusion.

3

INSTALLATION

Self-tapping Phillips head screw

(large)

Never mount the unit near the fuel tank.

The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (left and right side), must
correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration
compensation will not be effective and vibration may cause the disc to skip.

position "H"

position "V"

position "45°"

Bracket

Bracket

Bracket

Hex head bolt
with washer base

NOTE: Make sure anti-vibration springs

are set to position "H".

Set the anti-vibration springs to
position "H".

Set the anti-vibration springs to
position "V".

Set the anti-vibration springs to
position "45°".

H

45°

V

H

45°

V

H

45°

V

45°

H

45°

V

NOTE: If mounting surface is carpeted, use caution

when drilling holes to prevent drill bit from
catching on carpet. Cut holes in carpet
before drilling into sub-surface.

HORIZONTAL INSTALLATION

VERTICAL INSTALLAITON

45° ANGLE INSTALLATION

Advertising