Karcher Aspiratori SE 5-100 EU - Manual (Page 17)

– 10
Vacuuming carpeted floors
Illustration

Use your foot to press the reversing
switch of the floor nozzle. The brush
strips at the bottom of the floor nozzle
are retracted.
 Use the surrounding air separator to
adapt the suction force.
Note:
Close the surrounding air separator
again after use!
ṇ
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!

Remove the fresh and wastewater con-
tainers, vacuum the wet dirt directly into
the container.
 Use wash nozzles to vacuum moisture
or wetness.
 Once the wastewater container is full,
the appliance switches off automatical-
ly.
Note: Once the appliance shuts off,
switch off the appliance, because the
suction turbine will otherwise start run-
ning again once you open the appli-
ance.
If you use a crevice nozzle:

Attach and secure the adapter for wet/
dry vacuuming. Install the crevice noz-
zle directly to the adapter.
 Switch on the vacuum process.
 Turn off the appliance.
 Drain the full container.
 Rinse the reservoir thoroughly with
clear water.
 Separate the handle, the spray/suction
hoses and the wash nozzle from each
other; open locking lever to achieve this
(centre position),
 Flush the accessories separately under
running water and let air dry.
 Leave the appliance open to let it dry.
Illustration

Accessories storage: Suction hose,
suction pipes and accessories can be
comfortably stored on the appliance.
 Storing the appliance. Store the appli-
ance in a dry room.
ƽ
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorised customer service.
ṇ
Warning
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.
With an uneven spray jet.
Illustration

Loosen nozzle attachment and pull out,
clean or replace spray nozzle.
1 x year or as needed.
Illustration

Clean sieve.
For heavy contamination:
Illustration

Release the cover and fold it open, re-
move the flat fold filter and knock the
dirt out.
 Fill up fresh water reservoir.
 Fresh water container sieve plugged.
 Thermal protection switch has switched
off the pump as it was overheated.
Switch off appliance and let it cool down
(approx. 20 - 30 min).
 Detergent pump defective, contact Cus-
tomer Service.
Wet vacuum cleaning
Finish operation
Maintenance and care
Clean the spray nozzle
Clean the sieve in the fresh water
reservoir
Clean flat fold filter
Troubleshooting
No water exiting from nozzle
17 EN