Karcher CV 38-2 Adv - Manual (Page 12)

– 3
ƽ DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
 Clean the brush roller.
 Dismount the brush cover if necessary:
Turn the turn-lock fasteners by 90° and
remove the brush cover.
 Cut hair and threads that have got
wound on the brush roller using a pair of
scissors or just remove them.
 Unlock and remove the filter cover.
Illustration

Turn the locking mechanism of the filter
bag towards the right. Close, remove,
and dispose of the filter bag.
Illustration

Insert a new filter bag and turn the lock-
ing mechanism of the filter bag towards
the left.
 Insert and lock filter cover.
 Unlock and remove the filter cover.
 Push the locking mechanism of the filter
casing upwards and remove the filter
casing.
 Remove the exhaust filter from the filter
housing.
 Insert new exhaust filter into filter hous-
ing.
 Insert and click the filter housing into its
place.
 Insert and lock filter cover.
 Unlock and remove the filter cover.
 Push the locking mechanism of the motor
protection filter upwards. Remove and
dispose of the motor protection filter.
 Install and lock the new motor protec-
tion filter.
 Insert and lock filter cover.
 Dismount the side part by means of a
coin.
 Pull out the brush roller and dispose of.
 Insert a new brush roller.
 Reinstall side part.
ƽ DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
Illustration
Illustration
Illustration
Note: If necessary, dismount brush cover
(refer to "Cleaning of the brush roller").
– No electrical voltage.

Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
– Thermostat switched off the motor be-
cause of overheating
 Replace blocked filters or remove
blockages from the suction hose.
The unit is operational again after it has
cooled down.
 Check the brush roller for obstructing
objects and remove them if necessary.
 Remove obstructions from brush head,
suction pipe and suction hose.
 Replace the filter bag.
 Replace exhaust air filter or motor pro-
tection filter.
 Check the pile height adjustment knob
for correct adjustment.
 Replace the brush roller.
Maintenance and care
Maintenance intervals
Daily
Cleaning the brush roller
Replacing the filter bag
Replace exhaust filter
Replace motor protection filter
Replacing the brush roller
Troubleshooting
Remove blockings
Suction pipe/suction hose
Suction hose on the brush head
Brush roller/brush head
Motor does not run
Unsatisfying suction result
12 EN