Karcher IVC 60-24-2 Tact M - Manual (Page 18)

– 3
The machine is equipped with a suction
power monitor. The control lamp lights up if
the air speed in the suction hose falls below
20 m/s.
Note: The control lamp can light up occa-
sionally during normal operation (e.g.,
while working with a floor nozzle), if the air
volume comes down (cross-sectional re-
duction) causing a low pressure.
Note: There is no defect in this case; only
an indication that, as specified above, the
air volume has reduced and the low pres-
sure has increased.
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks due to attachments (option)
with electrical conductivity.
Caution
The flat pleated filter must must always be
in place while vacuuming.
ṇ
Warning
Health risk on account of fine dust! If the
suction hose is removed, the suction con-
nection must be closed.
Illustration

Properly insert the connection socket in
the suction connection.
 Push in the connection socket until it
locks into place.
 Turn the suction connection with the
connection socket to the right to close it
tightly.
Note: The accurate fit is ensured by means
of a "bayonet connection".
Note: The dirt container needs to be emp-
tied if it is full until about 3 cm below the up-
per rim.
– Check the fill level of the dirt container
at regular intervals, as the appliance
does not shut off automatically.
– The appliance is fitted with a disposal
bag, order no. 6.907-336.0 (5 ea.).
Note:You can use this appliance to take up
all types of dust up to dust class M. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
Note:The appliance is suited as industrial
vacuum cleaner to take up dry, non-com-
bustible dusts with MAK values greater
than or equal to 0.1 mg/m
3 .
– To vacuum fine dust, you must use an
additional disposal bag.
Caution
Please note the following when switch-
ing from wet to dry vacuum cleaning:
If you vacuum dry dust while the filter ele-
ment is still wet the filter will become ob-
structed and may be damaged beyond
repair.

Dry the wet filter properly before use or
replace it with a dry one.
 Change the filter, if required, according
to instructions under the section "Main-
tenance and Care".
 Lock parking brakes.
Illustration

Remove the pressure balancing at the
upper end.
 Pull the locks of the placement mechan-
ics up.
 Pull the push handle upward. The con-
tainer is unlocked and lowered.
Illustration

Pull the container out by the handle.
Automatic monitoring of suction
capacity
Anti-static system
Operation
Close the suction connection
Dirt receptacle
Dry vacuum cleaning
Installing the dust disposal bag
18 EN