Karcher IVC 60-12-1 Tact EC - Manual (Page 16)

– 4
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.

Release the park brakes and push the
appliance by the push handle.
 Grab the appliance by the chassis, not
by the sliding bow to load it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
ƽ
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
 Open filter door.
 Replace the flat pleated filter.
 Close the filter door, it must lock into
place.
 Pull the locks of the placement mechan-
ics up.
 Pull the push handle upward. The con-
tainer is unlocked and lowered.
 Pull the container out by the handle.
 Clean the thermal probe and the protec-
tive cover with a moist cloth.
 Replace the battery and lock it with the
sliding bow.
ƽ
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable, the power plug
and the thermal probe of the device.
 Turn on the appliance.
 Empty the container.
 Check whether the protective cover is
available and the side opening of the
protective cover points to the right
placement mechanics (see illustration
of appliance).
 Clean the thermal probe and the protec-
tive cover with a moist cloth.
 Turn the appliance off and back on.
 Clean the thermal probe and the protec-
tive cover with a moist cloth.
 Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
 Check the suction head and the recep-
tacle for proper seating.
 Ensure the filter cover properly locks
into place.
 Replace the flat pleated filter.
– Thermal protection device has switched
the motor into the emergency mode due
to overheating.
 Allow device to cool down.
Transport
Storage
Maintenance and care
Exchanging the flat pleated filter
Clean the thermal probe
Troubleshooting
Suction turbine does not run
Suction turbine turns off
Suction turbine does not start again
after the container has been
emptied
Suction capacity decreases
16 EN