Karcher NT 14-1 Classic - Manual (Page 13)

-
2
1 Filter cover
2 Flat fold filter
3 Suction hose
4 Suction head lock
5 Impeller
6 Dirt receptacle
7 Steering roller
8 Suction support
9 Floor nozzle
10 Suction pipe
11 Main switch
12 Carrying handle
13 Suction head
14 Electrodes
15 Filter frame lock
16 Filter frame
17 Bender
18 Exhaust filter
19 Storage for suction pipes
20 Power cord
21 Storage for floor nozzle
22 Exhaust air outlet
23 Nameplate
Caution
The flat pleated filter must must always be
in place while vacuuming.
– To vacuum fine dust, you can also use
an additional paper filter bag or a fleece
filter bag.
Illustration

Release and remove the suction head.
 Place the paper or fleece filter bag.
 Insert and lock the suction head.
Illustration

Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
– To vacuum wet dirt, first remove the pa-
per or fleece filter bag.
Caution
The flat pleated filter must must always be
in place while vacuuming.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After the wet vacuuming: Clean the
electrodes with a brush. Clean the con-
tainer with a damp rag and dry it.
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
 Plug in the main plug.
 Switch on the appliance at the main
switch.
 Perform the cleaning operation.
 Switch off the appliance at the main
switch.
 Pull out the mains plug.
Device elements
Start up
Dry vacuum cleaning
Inserting the paper filter bag
Wet vacuum cleaning
Inserting the rubber lips
Remove the paper filter bag
General
Clip connection
Operation
Turning on the Appliance
Cleaning operations
Turn off the appliance.
13 EN