Audiovox Jensen MP6512i - Manual (Page 11)

MP6512i
7
OPERATION
Power
Press the power button (2) to turn the unit on. Press and hold the power
button again to turn the unit off.
NOTE: LCD panels may take longer to respond when subjected to cold
temperatures for an extended period of time. In addition, the visibility
of the numbers on the LCD may decrease slightly. The LCD display
will return to normal when the temperature increases to a normal
range.
Source
Press the SRC button (7) to select a different mode of operation, as
indicated on the display panel. Available modes include tuner (FM1, FM2,
FM3, AM1, AM2), CD, auxiliary (AUX), SD, USB, SAT and iPod. CD, SD,
USB, SAT and iPod mode only appear when the source is available.
Audio Mute
Press the mute button (2) to silence the audio volume. “Mute” appears on
the display. Press mute again to restore volume to the previous setting.
Volume / Audio Control
To increase the volume, turn the rotary encoder (22) clockwise. To decrease
the volume, turn the rotary encoder counter-clockwise. When volume is
adjusted, the volume level will be shown on the display panel as a number
ranging from “0” (lowest) to “46” (highest).
Press the MENU button (22) to access the audio menu. Turn the rotary
encoder to step through the following audio functions: bass (BAS), mid-
range (MID), treble (TRE), balance (BAL), fader (FAD), subwoofer (SUB)
and volume (VOL). The unit automatically exits audio control mode after five
seconds of inactivity.
Bass
To adjust Bass options, press the MENU button (22) to access the audio
menu. Turn the rotary encoder until “BASS” appears in the display. Press
the MENU button repeatedly (22) to access the following Bass settings:
•
Bass Center Frequency
Turn the rotary encoder clockwise to adjust the Bass Center Frequency
to 60, 80, 100 or 200.
• Bass
Turn the rotary encoder clockwise to increase or counter-clockwise to
decrease the Bass level from “-6” to “+6”. “0” represents a flat response.
•
Bass Quality Factor
Turn the rotary encoder to select one of the following Bass Quality
Factor options: Q1, Q2, Q3, Q4. The following chart depicts the curve
characteristics for each step:
MP6512i
/
SAT
READY
UNIVERSAL SERIAL BUS
Bass Quality Factor Curve Characteristics