AT&T TL7610 - Manual (Page 39)

33
Registration and de-registration
Adding and registering headset to headset base
To register a headset to the headset base:
Make sure the battery is properly installed in the
headset (see page 12). The
ON/OFF light flashes
twice every five seconds to indicate the headset
is not registered.
Place the headset in the headset base and allow
it to charge for at least five minutes before
beginning registration.
Remove the headset from the headset base.
Press and hold the
PAIR button until the MUTE
light on the headset base turns on (about four
seconds) and release the button.
Return the headset to the headset base for
registration.
Registration may take about 30 seconds to
complete. The
MUTE light on the headset base
turns off. The headset ON/OFF light turns blue
on the first headset registered. The headset
ON/OFF light turns orange on the second
headset registered.
To verify registration was successful, press the
headset
ON/OFF button and check for a dial
tone.
If the registration is not successful, the
ON/OFF light on the headset flashes twice
every five seconds. To reset the headset, remove
the headset from the headset base and try the
registration process again.
1.
2.
3.
4.